PRESS the device key you would like the volume to come from.This sets Volume to work for one device in all modes.įor example, the TV volume will work in the cable and VCR modes. "SETUP" (2 blinks) 9 - 9 - 2, TV (you want to move TV) PRESS the DEVICE key you want to replace.Įxample: If you want the Aux key to be a TV key:.PRESS the DEVICE,(TV,VCR,CABLE,etc.),key you want moved.If the remote DOES NOT blink it means the number is 0. PRESS 3, carefully COUNT the number of blinks.
PRESS 2, carefully COUNT the number of blinks.PRESS 1, carefully COUNT the number of blinks.PRESS the device,(TV,VCR,CABLE,etc.), button - RELEASE.When your device turns OFF, PRESS the SETUP button and RELEASE it to lock in the code for your device.Make sure that the remote is pointed at your device during the search, You may have to press this sequences of buttons up to 100 times to search the entire library of codes. ALTERNATE slowly between the POWER key and the DEVICE(TV,VCR,CABLE,etc.) button until your device turns off.(On VCR,LD,and CD players use PLAY instead of POWER).If you have tried all of the set-up codes for your brand of eqipment, or your brand is not listed, and you are still not able to get the unit to respond, try the following proceedure to search for your code.
PRESS the POWER button to test the code.You should receive 2 quick flashes after entering your code.PRESS and HOLD the SETUP button until the red LED flashes twice, then RELEASE.PRESS the button for the device you want to program,(TV,VCR,CABLE,etc.), then RELEASE.
How to Program your One For All® remote ( URC-5060, URC-5061, URC-5062, URC-5063, URC-5065 )Īfter getting the proper codes from your manual or Customer Service, use the following instructions to enter them into your remote. Everything under control with the official One For All homepage.